Jimbo's toy
Member
Hey guys, I have been trying to figure out an issue with the rear washer on my 2005 Sequoia. The wiper works fine, but the washer didn't work when I got the truck, but I just figured I would fix it at some point.
The front washer works fine, but I have had a frustrating search for any info on the rear washer. (No Youtube videos)
The washer pump and reservoir are buried deep in the engine compartment and are very difficult to access.
I've been told the only way to get to the tank is remove the front right wheel and take out the inner fender liner.
Thats a bit difficult in New Hampshire in the winter with no garage.
So I'm hopeful that someone on this forum can at least tell me how the system is designed. Is there just one pump or two? Where does the line run, under the truck or inside. If inside is it under the upper or lower trim panels?
I've even looked in the rear for a separate tank and pump, but no luck.
Does anyone have any ideas?
The front washer works fine, but I have had a frustrating search for any info on the rear washer. (No Youtube videos)
The washer pump and reservoir are buried deep in the engine compartment and are very difficult to access.
I've been told the only way to get to the tank is remove the front right wheel and take out the inner fender liner.
Thats a bit difficult in New Hampshire in the winter with no garage.
So I'm hopeful that someone on this forum can at least tell me how the system is designed. Is there just one pump or two? Where does the line run, under the truck or inside. If inside is it under the upper or lower trim panels?
I've even looked in the rear for a separate tank and pump, but no luck.
Does anyone have any ideas?