Recent content by jjmead1

Thanks for your input. I ended up placing the jack under the lower ball joint and raising it a bit. This changed the angle of entry just enough for the axle to go right in smoothly. Raised it about 1 inch and the thing was easy to get into place. My next step was to do as you suggested, but I...

Pardon the descriptions, as I am sorta a noob. It is catching, I did remove the sway bar link, as the bushings were shot as well. I feel like I need to do as you suggested and drop the arm, how hard is this and I believe there is a tool I would need? It seems possible but I am not sure. I...

I had a heck of a time removing the drive shaft, seems like the steering boot assembly gets snagged on everything. I finally tapped it out, carefully. I for the life of me cannot get he new assembly in. I cannot either bend the joints enough to provide a good entry angle or push it in. the bot...