Search results

You will want around 9 threads showing above the nut. Bilstein 6112's and DirtyDeedsIndustries upper arms. by Keith Carty, on Flickr Remove from spring compressor and this is the beautiful collection of parts that will show up on your door step all ready for install Bilstein 6112's...

At Sema 2014 Bilstein introduced their 6112 bolt in coilover for our 07+ Tundra's. But due to some unforseen circumstances they couldn't release them until spring of 2015. Since this release we here at DirtyDeedsIndustries have been doing some extensive research on how to properly set up the...

here's what you do: Lift up the back of the truck. Put jack stands under the rear end to keep both rear tires off the ground. Use a piece of chalk or some white out and mark the driveshaft at the 6:00 position. Do the same with the passenger rear tire. Spin the tire and count how many times the...

After like 5 years the conversation came up at Chrismas. My uncle told her she had to not just check it but change it. So she did. The car was fine. By this time I was in high school and I helped her sell the car and she got something newer.

So...my supercharged 2013 has documented dyno numbers, and documented track numbers (in the 1/8th mile here in San Diego). And I was very hesitant to believe that the Bully Dog GT Platinum Tuner | Dirty Deeds IndustriesDirty Deeds Industries could possibly gain 90 HP like BullyDog was claiming:)...

ha, my mom owned an old Nissan Sentra when I was a kid (after parents got divorced) she would check and add oil as needed. But NEVER changed. Didn't know she had to. haha

BAmufflers is the only company that makes a full bolt on exhaust system for EVERY year Sequoia. This system uses a helmholtz resonator which eliminates the drone that a 4.7 inherently has. It also uses the stock tailpipe so that you don't lose lose low end torque. All that in a system that...

this is the most fun

2wd rock crawler

before a ton of revalving and building it was a little slower:

here's the traction bar that I built to keep the axle from wrapping up and binding up the driveshaft (as it was before the traction bar)

I've shot a few videos of my R&D truck. Thought it would be fun to post em up here. I even wrote a thread showing how to build the suspension here: How to make sweet Long Travel Suspension Here's some fun videos:)

if just a few spots use a terry cloth towel, all cotton, and water. That's it. If more than a few spots and the towel won't work, anything that you do will cause the headliner to separate from its backing. They're actually not that bad to change, just a matter of how much$$$$???

welcome from San Diego CA

here's both of my Tundra's: DirtyDeedsIndustries and BAmufflers in Northern Cali. by Keith Carty, on Flickr The one on the trailer has 160K

just plain water;) if selling than any of the above. But if you intend to keep the vehicle just use water. Anything else attracts dirt and before you know it you're constantly wiping down your interior. I've had my 2003 Tunda since it was brand new. When the dash gets dirty I can blow it off...