Recent content by Sam

New cylinder heads and cams

I did completely disassemble ,clean and inspect everything, There was no metal circulated through the motor because when it let loose it went instantaneously, the Timing belt broke at high speed and all hell happened !

Yes to both, the block was hot tanked,bored .020 over, New oil pump ,cylinder spray tubes were cleaned, the only old parts reused were the cam phazers but I cleaned and inspected them, I did notice the dowel pin hole has a little mark where the cams were forced to stop but I didn't notice any...

I have a 4.7 06 tundra that was Blown up bad. I completely rebuilt the engine , Bored out and .020 over pistons, New connecting rods , 2 completely re-manufactured cylinder heads and cams. But I reused the cam phazers from the blown up engine , It runs great but sounds exactly like a Diesel...